Silvercrest SUSR 17 A1 - Manual (Page 14)

Scanradio SUSR 17 A1
14 - English
Setting the Alarm Clock
Verify that the clock displays the correct time. The alarm time can
only be set while the device is powered off. If it is still powered
on, power the device off by using the volume control knob (7).
 Press and hold the Alarm button (9).
 Then press the HOUR button (10) repeatedly to set the hours
of the alarm time. You can also keep the HOUR button (10)
pressed down to accelerate the digit adjustment. To
distinguish ante meridian (morning) and post meridian
(afternoon) time, "PM" will display for post meridian clock
hours.
 Keep the Alarm button (9) pressed. Then press the MIN
button (8) repeatedly to set the minutes of the alarm time.
You can also keep the MIN button (8) pressed down to
accelerate the digit adjustment.
 Release the Alarm button (9) after the alarm clock has been
set correctly.
Enabling the Alarm
After the desired alarm time has been set, you can enable the
alarm as follows:
 Press the AL ON button (4). The alarm icon will show on the
display (5).
 To disable the alarm, press the AL ON button (4) again. The
alarm icon will disappear from the display (5).