Safety instructions / getting started, Getting started, Replacing the battery – Silvercrest Z29852A Z29852B User Manual

Page 31: Unit conversion button

Advertising
background image

31

GB/MT

Safety Instructions / Getting started

children or animals swallowing them. Consult a

doctor immediately if a battery is swallowed.

J

EXPLOSION HAZARD! Never

recharge, short-circuit and / or open

batteries. This can cause them to

overheat, burn or burst. Never throw batteries

into fire or water. The batteries may explode.

J

Avoid extreme conditions and temperatures

which can affect batteries, e. g. heaters. Other-

wise there is an increased risk of leakage.

J

Check regularly that the battery is not leaking.

J

Leaked or damaged batteries can

cause chemical burns if they come

into contact with the skin; in such

cases you must wear suitable protective gloves.

J

Avoid contact with the skin, eyes and mucous

membranes if fluid has leaked from the battery.

In the event of contact with battery acid, rinse

the affected area with plenty of clean water

and consult a doctor immediately.

J

Remove light dirt from the battery and product

contacts with a dry, non-fluffing cloth before

inserting the batteries.

J

Remove the battery from the product if it is not

in use for any length of time.

J

Make sure that the polarity is correct when you

insert the battery. This is indicated in the battery

compartment. The battery can otherwise explode.

J

Insert the battery with care. The product can

otherwise be damaged.

J

Please do not dispose of used batteries in your

household waste but take them to a designated

collection depot for special waste.

Q

Getting started

1. Open the battery compartment

15

under the

scale by pushing the clip

7

on the battery

compartment cover

8

towards the battery

compartment and lift up the cover.

2. Remove the battery isolating strip

16

from under

the battery metal contact to which it is attached.

3. Place the battery compartment cover

8

back

on the battery compartment

15

. Ensure that the

two extensions

13

on the battery compartment

cover

8

fit into the two notches

14

on the

edge of the battery compartment opening

when the cover is closed. Press the battery

compartment cover

8

firmly on to the battery

compartment

15

until you hear it engage.

16

11

12

Q

Replacing the battery

1. Switch off the scale. Press and hold down the

On / Off / Zero button

5

for 3 seconds.

2. Open the battery compartment

15

as described

above.

3. Remove the exhausted batteries from the battery

embedding case

11

by pressing the black bat-

tery locking tab

12

. The battery is automatically

released from the battery embedding case

11

.

Ensure that you do not exert too much force on

the contact

10

, otherwise it could be damaged

by over-bending as the battery is lifted. Remove

the battery from the battery embedding case

11

.

4. Insert a new battery into the battery embedding

case

11

. Make sure you fit the battery the right

way round (polarity). The “+”- side must face

upwards. The metal contact

10

presses battery

into position.

5. Close the battery compartment

15

as described

above.

Q

Unit conversion button

j

The unit conversion button

9

for the units of

weight can be found on the bottom of the kitchen

scale. By simply pressing the button the units of

measure change between metric (g, ml) and

imperial (lb:oz, fl’oz).

Note:

– If the units of weight are set to metric (g) then

the units of volume will be automatically shown

as ml.

79419 CB5 IM.indd 31

1/2/2013 3:33:07 PM

Advertising