Silvercrest SZP 40 A1 - Manual (Page 31)

29 GB
~ Only connect the mains plug to a prop-
erly installed and easily accessible wall
socket whose voltage corresponds to
the specifications on the rating plate.
The wall socket must continue to be eas-
ily accessible after the device is
plugged in.
~ Ensure that the power cable cannot be
damaged by sharp edges or hot points.
~ The device is not fully disconnected from
the power supply, even after it is
switched off. In order to fully disconnect
it, pull out the mains plug.
~ When using the device, ensure that the
power cable cannot be trapped or
crushed.
~ To pull the mains plug out of the wall
socket, always pull on the mains plug,
and never on the power cable.
~ Disconnect the mains plug from the wall
socket…
… if there is a fault,
… if you are not using the citrus press,
… before you assemble or disassemble
the citrus press,
… before you clean the citrus press and
… during thunderstorms.
~ To avoid any risk, do not make modifi-
cations to the device.
WARNING! Risk of injury by
turning parts
~ Do not touch the rotating juicer cone di-
rectly. Do not touch rotating parts with
small spoons or similar utensils. Keep
long hair or loose clothing away from
rotating parts as well.
~ Only plug the mains plug into the wall
socket after the device has been com-
pletely assembled.
WARNING! Risk of material
damage
~ Do not block and overload the motor.
Do not put excessive pressure on the
juicer cone.
~ Ensure that no foreign body is on the
screen or in the device when operating
it.
~ In order to avoid damage to the device,
interrupt pressing immediately, if the
juicer cone is not turning or having diffi-
culty turning. Pull out the mains plug
and check if there is a foreign body in
the device.
~ The device is fitted with non-slip silicon
feet. Because furniture can be coated
with a wide variety of varnishes and
plastics, and treated with various care
products, the possibility cannot be ex-
cluded that some of these substances
have ingredients that may attack and
soften the silicon feet. If necessary,
place a non-slip mat under the device.
~ Place the device on a stable, flat sur-
face.
~ Never place the device on hot surfaces
(e.g. hot plates) or near heat sources or
open fire.
~ Do not use any astringent or abrasive
cleaning agents.
4. Items supplied
1 Lid1
1 Juicer cone with screen2
1 Juice container3
1 Motor block6
1 Operating Instructions
5. How to use
• Remove all packing material.
• Check to ensure that all parts are pre-
sent and undamaged.
• Clean the device prior to its first
use (see “Cleaning” on page 30)!
__RP104443_B1.book Seite 29 Donnerstag, 20. November 2014 3:34 15