Silvercrest SZP 40 A1 - Manual (Page 32)

30 GB
6. Operation
6.1 Assembling the citrus
press
DANGER!
Only plug the mains plug8 into the
wall socket after the device has
been completely assembled.
1. Pull the desired length of power cable8
out of the cable compartment7.
2. Place the motor block6 on a dry, solid
and level surface.
3. Place the juice container3 on the motor
block6.
4. Place the juicer cone with screen2 on
the drive axle5.
5. Insert the mains plug8 into a wall sock-
et corresponding to the technical data.
6.2 Extracting the juice from
citrus fruits
WARNING!
~ Ensure that no foreign body is on the
screen2 or in the device when operat-
ing it.
~ Do not put excessive pressure on the
juicer cone2.
NOTES:
• Empty the juice container3 at the latest
when juice fills the container up to just
under the screen2.
• In order to achieve the largest juice
yield possible, the juicer cone changes
the direction of rotation after several
starts and stops.
1. Place a container under the outflow4.
2. Figure A: open the outflow4 by press-
ing lightly on the top.
3. Cut the citrus fruits in half.
4. Figure B: exert slight pressure on the
halves of the citrus fruit when pushing
the cut surface down onto the juicer
cone2. The juicer cone2 starts turning,
and the juice flows into the juice contain-
er3.
5. As soon as you stop pressing on the
juicer cone2, the device stops.
6. Figure C: when you have finished ex-
tracting juice, or want to change the
container under the outflow4, close the
outflow4 by pressing lightly from be-
low.
7. Clean the device after each use as soon
as possible so the pulp does not start
drying to the surface.
7. Cleaning
Clean the device prior to its first use!
DANGER! Risk of electric
shock!
~ Pull out the mains plug8 from the wall
socket before cleaning the citrus press.
~ The motor block6, the power cable
and the mains plug8 must not be im-
mersed in water or any other liquids.
WARNING!
Do not use any astringent or abrasive clean-
ing agents.
NOTE: clean the device after each use as
soon as possible so the pulp does not start
drying to the surface.
1. Remove the lid1, if necessary.
2. Remove the juicer cone 2 and the juice
container3.
3. Figure D: open the juice container out-
flow4, carefully press the sides togeth-
er and fully fold down the outflow.
4. Figure D: take the outflow4 out of the
bottom of the juice container3, and put
it in the basket of the dishwasher.
__RP104443_B1.book Seite 30 Donnerstag, 20. November 2014 3:34 15