Prior to use inserting the batteries, Connecting the earphones – Silvercrest SSR 10 A2 User Manual
Page 67
SilverCrest SSR 10 A2
English - 65
Prior to use
Inserting the batteries
First, insert the supplied batteries (C). To do this, open the battery
compartment at the back of the device by sliding the battery
compartment cover (9) to the side in the direction of the
imprinted arrow and removing it. Insert the batteries (C) with the
correct polarity (pay attention to the + and - marks). The polarity
is illustrated on the batteries and in the battery compartment.
Then slide the battery compartment cover (9) back on the device
housing until it snaps into place.
If the volume decreases or if the device is not working, replace
the batteries (C) with new batteries of the same type. The device
indicates via "Low battery power" (18) on the display (1) when
the battery capacity is exhausted.
Connecting the earphones
Insert the jack plug of the supplied earphones (B) as far as
possible into the earphone jack (8) on the side of the device.