Silvercrest SSR 10 A2 - Manual (Page 73)

SilverCrest SSR 10 A2
English - 71
SLEEP timer
With the SLEEP timer, you can set a time between 10 and 90
minutes after which your scan radio automatically switches off.
The setting is made in intervals of 10 minutes. Proceed as follows:
 Switch off the scan radio with the "On/Standby" button (6).
 Keep the "On/Standby" button (6) pressed until the display
(1) indicates the number 90 (for 90 minutes).
 Then press the "On/Standby" button (6) repeatedly until you
reach the desired number of minutes (for example, 40). Each
time you press the "On/Standby" button (6), the number of
minutes to switching off is reduced by 10 minutes.
 The scan radio then switches itself on and, after the previously
selected minutes (for example, 40), it switches itself off
automatically.
 The display (1) indicates "SLEEP" (20) when the SLEEP timer is
activated.
 You can start the station scan or access saved stations even
when the SLEEP timer is activated.
 You can delete the activated SLEEP timer by switching off the
scan radio.
Setting the alarm time (Alarm 1 / Alarm 2)
You can set 2 alarm times. Make sure that the time is set
correctly. You can set the alarm time only when the device is
switched off. Switch off the device with the "On/Standby" button
(6) if it is switched on.