Efficient Networks EEE 802.11b/g Wireless USB 2.0 Adapter - Manual (Page 37)

IEEE 802.11b/g Wireless USB 2.0 Adapter Version 1.2
37
h Key Entry: Select Hexadecimal or ASCII depending on the WEP key
that is used.
h WEP Key Size: Select 64, 128, or 152 bit WEP key size.
h Transmit Key: Enter the WEP key in the four WEP key text boxes.
Click on the OK button to return to the previous window
3.2.4 Advanced Settings
Click on the Advanced tab in the Profile Management section. Here you can
configure the transmit power level, wireless mode, power save mode, and
network type.
3.2.4.1 Infrastructure Settings
h Wireless Mode: Place a check in the preferred frequency and data
rates.
h Power Save Mode: Select Maximum, Normal, or Off from the drop-
down list. Selecting Maximum will save the most power; this is
recommended if using a laptop running on battery. For other instances,
use the Normal of Off setting.
h Network Type: Select Infrastructure from the drop-down list.
h 802.11 Preamble: This setting should be the same as the access point.
If you are not sure of that setting, select Short & Long.
h Preferred APs: Click on this button to add specific access points to this
profile. Then enter the MAC addresses of the specific access points and
then click on the OK button to return to the previous window.