Elmo Ceiling Presenter HV-C1000XG - Manual (Page 16)

11
15
1
2
3
4
5
6
7
8
9
10
■ Connection to the analog RGB-out terminal
Connect the Analog RGB-out Terminal [RGB OUT] to the equipment with an analog RGB-in
terminal with the analog RGB cable (attached) or a connection cable available on the market.
At this time, the position of the display may be deviated from the center. If deviated, manually
adjust the horizontal and vertical positions on the connected equipment.
Also, vertical stripes may appear on the screen of the LCD projector. That can be alleviated
by manually adjusting the dot clock frequency on the projector.
■ Connection to the composite video-out terminal
Use the Composite Video-out Terminal [VIDEO](RCA pin) and the video cable with RCA pin
plug as attached or available on the market.
■ Connection to the S video-out terminal
Use the S Video-out Terminal [S-VIDEO](Mini DIN 4P) and the S-Video cable as attached or
available on the market.
Hold the cable plug when connecting or disconnecting the cables.
S-VIDEO USB MOUSE
RGB OUT RS-232C AC IN POWER
VIDEO
LCD projector
CRT monitor
or
S-VIDEO USB MOUSE
RGB OUT RS-232C AC IN POWER
VIDEO
TV monitor
S-VIDEO USB MOUSE
RGB OUT RS-232C
AC IN POWER
VIDEO
TV monitor
Connection to Monitor and Projector
The following settings of this product can be made with the DIP Switches. Make the settings
according to the connection environment. The factory settings are as shown in the following
table:
Be sure to turn OFF the power supply to all equipment before making any connections to
protect this product and all the connected equipment.
When changing the DIP Switch keys, be sure to turn OFF the power supply to this product
beforehand.
Key
A
B
To change the Video output type
To change the screen size of Video output
Function Key selection
Initial setting
NTSC
Over scan
1
0
Content