Silvercrest SLE 320 A1 - Manual (Page 14)

11 SLE 320 A1
GB
Handling and operation
In this section, you will receive important information pertaining to appliance
handling and operation.
Switching the appliance on/off
♦ Press the STANDBY button 21 to switch the appliance on. The OPERATION
LED 20 lights up.
♦ Press the STANDBY button 21 to switch the appliance off . The OPERATION
LED 20 goes out.
NOTE
► The appliance starts in the mode last selected.
► After a power failure, if the appliance is disconnected from the mains, or
after switching off owing to the overheating guard, the appliance starts in
the mode last selected.
♦ If a timer has been programmed, the appliance switches off defi nitively
upon lapse of the time specifi ed (1-24 hour/s).
♦ If the relative humidity value has been defi ned in the TARGET HUMIDITY
programme, the appliance switches off once the value has been attained.
If the value is exceeded, the appliance switches on again.
♦ The appliance switches off if the water tank 5 is full or has been removed.
If wrongly positioned, or if the water tank 5 has been removed, the TANK
FULL LED 19 lights up when the appliance is switched on and an audible
signal is emitted.
NOTE
► The water tank 5 must be fully inserted in the appliance; otherwise, the
condensate cannot be collected properly.
Air outlet valve
Always open the air outlet valve, regardless of the appliance's respective pro-
gramme. If the valve is not opened, the overheating guard switches the appli-
ance off after some time for approx. 3 minutes.
IB_96805_SLE320A1_LB4.indb 11 24.07.14 11:56