Powerfix PTW 1500 A1 - Manual (Page 9)

PTW 1500 A1 7
1. Select a place to put the appliance:
– which complies with the safety
instructions (see “4. Safety
instructions” on page 4 and
following);
– no more than 5 m from the wall socket
or wall connection
– which is somewhat sheltered, so that
the appliance is not shaken
excessively by strong winds;
– which enables the appliance to be
swivelled down by 45°;
– at least 1 m from people, animals and
plants
– with a wall that is sufficiently strong;
– which complies with the distances
shown in the sketch below:
Note: The appliance is manufactured
entirely of rust-proof materials and can
be exposed to normal environmental
influences.
2. Drill 3 holes with diameter 10 mm in the
wall, to match the holes in the fastening
bracket 10. The drilling depth is approx.
55 mm.
3. Clean the drill hole from the drilling dust
because the wall plugs 9 could
otherwise jam.
4. Insert the wall plugs 9 into the holes. You
can help with light hammers. The thread
may not be damaged thereby.
5. Firmly screw in the fastening bracket 10.
Note: We recommend fastening the
appliance to a solid wall of masonry or
concrete.
6. Secure the appliance to the fastening
bracket 10 using the supplied wing nuts
with bolts 8.
7. Adjust the appliance to the desired
swivel angle.
8. Tighten all bolts.
Note: You should make regular checks
to see whether any bolts have loosened.
Re-tighten the bolts if necessary.
5.3 Electrical connection with plug
Insert the mains plug into a wall socket that
complies with the technical data (see
“3. Technical data” on page 3).
Notes:
• The appliance consumes up to 7 amps
(1500 watts) of electricity. If you have
plugged other power consumers into the
same circuit, check that the maximum
load for the installed fuse is not
exceeded, as otherwise the fuse will trip.
min. 20 cm
min. 50 cm
min. 180 cm
Wall plug 9
Wall
Fastening bracket 10
Nut
Spring washer
Plain washer
Slots
10 x 55 mm
RP7 68 49 TerrassenHS LB4 Seit e 7 M o nt ag , 11. J uni 2012 4:12 16