Hotpoint Ariston CG65SG1 (W) IT/HA H - Manual (Page 19)

GB
19
WARNING! The glass lid can break in if it
is heated up. Turn off all the burners and
the electric plates before closing the lid.
*Applies to the models with glass cover
only.
Replacing the Triple ring burner nozzles
1. Remove the pan supports and lift the burners out of
their housing. The burner consists of two separate
parts (see pictures).
2. Unscrew the nozzles using a 7 mm socket spanner.
Replace the nozzles with models that are configured
for use with the new type of gas (see Table 1). The
two nozzles have the same hole diameter.
3. Replace all the components by completing the
above operations in reverse order.
• Adjusting the burners’ primary air :
Does not require adjusting.
• Setting the burners to minimum:
1. Turn the tap to the low flame position.
2. Remove the knob and adjust the adjustment screw,
which is positioned in or next to the tap pin, until the
flame is small but steady.
3. Having adjusted the flame to the required low
setting, while the burner is alight, quickly change the
position of the knob from minimum to maximum and
vice versa several times, checking that the flame
does not go out.
4. Some appliances have a safety device
(thermocouple) fitted. If the device fails to work
when the burners are set to the low flame setting,
increase this low flame setting using the adjusting
screw.
5. Once the adjustment has been made, replace the
seals on the by-passes using sealing wax
.
! If the appliance is connected to liquid gas, the
regulation screw must be fastened as tightly as
possible
! Once this procedure is finished, replace the old rating
sticker with one indicating the new type of gas used.
Stickers are available from any of our Service Centres.
! Should the gas pressure used be different (or vary
slightly) from the recommended pressure, a suitable
pressure regulator must be fitted to the inlet pipe (in
order to comply with current national regulations).
! In order to prevent ac-
cidental tipping of the
appliance, for example
by a child climbing
onto the oven door, the
supplied safety chain
MUST be installed!
The cooker is fitted
with a safety chain to
be fixed by means of a
screw (not supplied with the cooker) to the wall behind
the appliance, at the same height as the chain is atta-
ched to the appliance.
Choose the screw and the screw anchor according to
the type of material of the wall behind the appliance.
If the head of the screw has a diameter smaller
than 9mm, a washer should be used. Concrete wall
requires the screw of at least 8mm of diameter, and
60mm of length.
Ensure that the chain is fixed to the rear wall of the
cooker and to the wall, as shown in figure, so that after
installation it is tensioned and parallel to the ground
level.
WARNING! The oven is
provided with a stop sys-
tem to extract the racks
and prevent them from
coming out of the oven.(1)
As shown in the drawing,
to extract them comple-
tely, simply lift the racks,
holding them on the front
part, and pull (2).