Hotpoint Ariston TB 060C AX0 - Manual (Page 15)

15
it en
1. Place the base on a level and sturdy surface.
2. Put the food into the glass jar.
Cut ingredients into small pieces (max 2-3
cm).
3. Close the glass jar lid.
4. Place the glass jar on the base and plug the unit
into an appropriate mains socket.
5. Fill the water in the water tank, then ensure the
water tank lid is closed.
6. Press the ‘on/off’ button to put the unit into
‘stand-by’ mode.
7. Set the cooking time, by pushing + or - buttons.
The cooking time can be changed at any time
during the cycle.
8. Press the Start/Stop button to start cooking.
9. When the cooking time has elapsed, the unit will
beep.
10. Turn control knob to blend the soup.
Due to unavoidable condensation, and to
natural amount of water contained in any
ingredients, in some situations to discharge a cer-
tain amount of liquid before blending is recom-
mended.
If you want to steam without the foods come
in contact with the condensation water, you
can use the basket.
The maximum fill for hot ingredients is 1400
ml.
When cooking or blending hot liquid it is es-
sential the glass jar lid and measuring cup
are left on the blender to prevent harm.
blending Cold Ingredients
The blender can also be used as a regular blender to
blend cold ingredients and crush ice.
1. Place the motor base onto a flat, sturdy surface.
2. Position the Glass jar assembly on the base and
plug into a suitable mains socket.
3. Add all necessary ingredients into the glass jar
and put the lid. You may add more ingredients
during blending by removing the measuring cup
and dropping ingredients through the opening
in the lid. If adding more liquid, we recommend
pausing blending, adding the liquid and replacing
the measuring cup to prevent liquid escaping.
The maximum fill for cold ingredients is
1750 ml.
Assembling (A)
1. To fit the Glass Jar Assembly to the base of the
Steam blender, position jar unit on the motor
base so that the arrow on the jar collar is aligned
to the arrow on the base. Push the jar down into
place.
Take care when placing the glass jar on the
motor base as incorrect positions may da-
mage the interlock switch and could prevent the
unit from running.
2. When you have added the required ingredients
to the jar, place the lid on jar before heating or
blending. Simply position the lid over the jar and
press down firmly (ensure the pouring spout on
the jar is covered by the protrusion on the lid).
3. Place the water tank by sliding along the rail on
the motor base until it engages.
Place the water tank lid to protect the water
from dust, insects and other foreign matter.
Disassembling
1. Switch the Steam blender off and unplug from
the mains socket. Lift the Glass Jar up and away
from the motor base.
Holding the handle only. Do not twist the jar.
The heating element is hot when the Steam
blender is in heat mode, do not touch the un-
derside of the collar.
2. To remove the lid from the glass jar, grip the
handle of the lid firmly with one hand and lift
upwards.
3. To remove the measuring cup from the lid, lift up
and away. To position the measuring cup over
the lid, aligning with the corresponding grooves
in the lid.
Steam will escape around the measuring cup
when the Steam blender is in heat mode, this
is normal, but handle with care – steam can burn.
Always ensure the lid and measuring cup are
positioned before blending.
Making Soup
Always cook food before blending.