Epson Stylus Photo TX710W - Manual (Page 82)


Error Messages Solution
Paper jam R & 90
A printer error has occurred. Turn power off and then on
again. For details, see your documentation. R & 95
Cannot recognize photos. Make sure photos are placed
correctly. See your documentation. R & 26
Communication error. Make sure the computer is
connected, then try again. Make sure the computer is connected correctly. If the error message still
appears, make sure that scanning software is installed on your computer
and that the software settings are correct.
The printer’s ink pads are nearing the end of their
service life. Please contact Epson Support. Contact Epson support to replace ink pads before the end of their
service life. When the ink pads are saturated, the printer stops and Epson
support is required to continue printing.
The printer’s ink pads are at the end of their service life.
Please contact Epson Support. Contact Epson support to replace ink pads.
The print head cannot be cleaned completely with Auto
Head Maintenance. See your documentation. Clean the print head from the Maintenance menu in Setup mode.
If quality does not improve, contact Epson support. To continue printing,
set the Automatic Head Maintenance to off from the Maintenance
menu in Setup mode.
Error in the data. The document cannot be printed. The
data is not available because of a malfunction in the
sending device. See the documentation for the device transmitting the data.
Error in the data. The document may not be printed
correctly. A part of the data is corrupted or cannot be
buffered. See the documentation for the device transmitting the data.
Backup Error.
Error Code xxxxxxxx A problem occurred and backup was canceled. Make a note of the error
code and contact Epson support.
The combination of IP address and subnet mask is
invalid. See your documentation. Refer the online User’s Guide - Networking.
Error Messages
Messages d’erreur
Fehlermeldungen
Foutmeldingen
EN
EN
R & 82
FR
DE
NL R & 85
R & 84
R & 83