Epson EB-1460Ui - Manual (Page 88)

Installation Guide
87
When installing the Touch Unit on the whiteboard (without using the Touch Unit
Bracket)
About installation
• There are magnets built into the back of the Touch Unit. Normally, the Touch Unit should be installed by attaching
the magnets to the screen.
• If the magnets cannot be attached to a screen, use commercially available M4 screws (x3).
• Attach the Touch Unit to the same level surface as the screen surface.
Installation Procedure
Install the Touch Unit, and then connect to the projector.
Caution
Only connect the Touch Unit to the EB-1460Ui/EB-1450Ui. Do not connect it to any other projectors or
devices.
a
Turn on the projector, and then press the [Menu] button
Using the Remote Control Using the Control Panel
b
Select Easy Interactive Function from Extended