Encore electronic ENMGS-16+2 - Manual (Page 22)

Combo mini-GBIC Ports (Port 15~16)
The Switch is equipped with two combo mini-GBIC ports, supported
optional 1000BASE-SX/LX mini-GBIC module.
The 1000BASE-T port 15 and 16 are the same ports with the mini-
GBIC port 15 and 16, when plug in the mini-GBIC module, the device
will activate mini-GBIC, and the RJ45 port will be disabled.
Rear Panel
The rear panel of the Switch consists of an AC power connector and
Reset button. The following shows the rear panel of the Switch.
Figure 5. Rear panel
AC Power Connector:
This is a three-pronged connector that supports the power cord. Plug
in the female connector of the provided power cord into this
connector, and the male into a power outlet. Supported input voltages
range from 100-240V AC at 50-60Hz.
Reset:
The Reset button is to reset all the setting back to the factory default.
Note: Be sure that you recorded the setting of your device, else all
the setting will be erased when pressing the “Reset” button.
14