Elation Professional X-Fogger - Manual (Page 5)

3
!
Never aim the output nozzle at open flames.
!
If the supply cord is damaged, it must be replaced by
manufacturer or its service agent or similarly qualified
personnel in order to avoid a hazard.
!
The output nozzle becomes very hot during operation
0 (300 C). Keep flammable materials at least 50 cm away
from the nozzle.
!
Always allow your ANTARI X Fogger to cool down
before attempting to clean or service it.
!
Never add flammable liquids of any kind (oil, gas,
perfume) to the fog liquid.
!
Use only the high-quality, water-based ANTARI fog .
Other fog liquids may cause clogging or "spitting".
!
Always make sure there is sufficient liquid in the fog
liquid tank. Operating this unit without liquid will
cause damage to the pump as well as over-heating of
the heater.
!
If your ANTARI Fog Machine fails to work properly,
discontinue use immediately. Drain all fog liquid from
the tank, pack the unit securely (preferably in the
original packing material), and return it to your
ANTARI dealer for service.
!
Always drain tank before mailing or transporting this
unit.
!
Never drink fog liquid. If it is ingested, call a doctor
immediately. If fog liquid comes in contact with skin
or eyes, rinse thoroughly with water.
Danger of Explosion
Important:
Pay attention to all warning labels and instructions printed on the
exterior of your ANTARI Fog Machine.