MCZ Forma PURO 115 - Manual (Page 16)

Chapter 4
INSTALLATION AND USE MANUAL
page
16
Installation and assembly Technical service – MCZ S.p.A. all rights reserved - Reproduction prohibited
• A = 100 mm (distance from the sides and back)
• B = 80 mm (height above floor)
If the stove is positioned over a floor or close to
walls made of flammable materials, it is advisable to
use sufficient insulation.
The hot air outlets must be placed at least 300 mm
from other materials. (e.g. curtains)
4.5. ADJUSTMENT OF HEIGHT AND BALANCING
The Forma Puro fireplace stove is provided with adjustment feet that
are to be screwed into the unit after you have decided its exact
position. Their purpose is to distance the stove unit from the floor and
to level the fire bed of the fireplace stove. They allow adjustment of
about 10 cm.
If you want to raise the fireplace stove more than 4 cm, you need to
create a masonry pedestal to set the product on. Do not eliminate
the feet. They are indispensable for levelling. Removing the
feet is considered a structural modification of the product and
therefore voids the guarantee.
In the VF forced ventilation configuration (i.e. with fan), you will need
to add the legs in the kit. Their purpose is to raise the fireplace stove
as shown in figure 5b. On the legs, you will need to install the provided
feet to adjust the level as described previously.
The levelling of the fireplace stove is essential so
that the fire door slides correctly.
If the floor is made of flammable material, the lower
part of the fireplace stove must be kept at least 8 cm
from the floor.
If the fireplace stove is not placed level, there is the
risk that door will not close perfectly, and that the
internal counterweights strike the structure, causing
noise each time the door is raised or lowered.
CHECK THAT THE DOOR MOVES CORRECTLY
SEVERAL TIMES BEFORE ENCLOSING THE FIREPLACE
STOVE IN THE CLADDING.
Figure 3b – Points of installation of castors and
feet
A
A A
B
Figure 3c – Safe distances