Edirol V1 video mixer - Manual (Page 14)

14
Turning the power on
Once the connections have been completed (p. 12), turn on power to your various
devices in the order specified. By turning on devices in the wrong order, you risk
causing malfunction and/or damage to TV monitor and other devices.
1
Check the power cable
Make sure that the power cable from the AC adaptor is firmly plugged into the V-1.
fig. power button.eps
2
Press the POWER button located on the rear of the V-1.
fig.06-03.eps
* Due to its circuitry-protection feature, the V-1 requires about five seconds after power-up
before it is ready for normal operation.
* The startup screen will appear in video (composite) output 2. This screen lets you check the
current system settings.
1
Press the rear panel POWER button
Press the POWER button located on the rear panel. All buttons and indicators on the
front panel will go dark.
Turning the power off
About the grounding connector
Depending on the conditions in which you use it, the V-1's panel may feel slightly
"gritty" to the touch. This is due to an extremely low level of static electricity that
poses absolutely no danger to you. However, if you find this annoying, you may
connect the grounding connector to an external ground. Under some conditions,
connecting an external ground may cause the video image to be disrupted. If you are
not sure how to connect the ground, consult a Roland service center.
Do not connect this to the following:
• Water pipes (may result in shock or electrocution)
• Gas pipes (may result in fire or explosion)
• Telephone-line ground or lightning rod (may be dangerous in the event of
lightning)