Precision Flight USB CAT I and X-Plane 9 User Manual
Page 2
USB CAT I and X-Plane 9 Set Up Guide 2 |
P a g e
Preface
This setup guide will walk you through the necessary steps to setup your USB CAT I System with
X-Plane 9.xx. It assumes that you have already installed the X-Plane 9.xx software. If you have not
installed the X-Plane 9.xx software, please install it now and refer to this guide once installation is done.
For reference on software installation, please refer to the software manual that you have received. For
connection diagram please refer to the packet that you received with the USB CAT I System.
USB CAT I System includes:
USB PFC Cirrus Yoke
USB PFC Throttle Quadrant Console
USB Avionics Panel with Remote Instrument Controller
USB PFC Cirrus Rudder Pedals
Setup steps:
The list below is the necessary steps that you will perform during installation.
A. X-Plane 9 Installation
– refer to the installation guide.
B. Installation of the PFCUSBHID plugin for X-Plane 9
– refer to the installation guide.
C. Connecting the CAT 1 System/s
D. Calibration of the components of the CAT 1 system
E. Assigning the components axes in X-Plane 9
F. Setting up displays.
G.
Set up the instructor’s station
Table of Contents