Precision Flight Serial CAT III and Microsoft Flight Simulator 9 (2004) - Manual (Page 6)

Serial CAT III and FS2004 Setup Guide Page 6
ELEVATOR CALIBRATION
6. Now click on Select button under the Elevator Axis. This should say Set Automatic now.
7. Pull your yoke all the way to the out and hold it. Click on the Set nose up limit.
8. Push your yoke all the way forward and hold it. Click on the Set nose down limit.
RUDDER CALIBRATION
9. If you have rudder pedals that those are enable now, but if you do not please uncheck
10. Now click on Select button under the Rudder Axis. This should say Set Automatic now.
11. Push your left pedals all the way to the Left and hold it. Click on the Set left most limit.
12. Push your right pedals all the way to the Right and hold it. Click on the Set right most limit.