Precision Medical PM4130 EasyPulse POC3 - Manual (Page 17)

16
Portable Oxygen Concentrator
MAINTENANCE / CLEANING
WARNING
• Prior to cleaning, ensure the POC is turned off and unplug any
external power sources.
• DO NOT disassemble or attempt to repair. There are no user
serviceable parts inside. Contact your Equipment Provider for service.
• DO NOT spray or apply any cleaners directly onto the case.
• DO NOT allow any liquids to drip inside any case openings.
• DO NOT use harsh and/or flammable chemicals to clean the device.
Perform cleaning as required.
Cabinet:
1. The patient should connect to an alternate Oxygen source.
2. Turn the POC to the “OFF” ( ) position.
3. Unplug the external power source before cleaning.
4. Clean exterior surfaces of the POC with a cloth dampened with
disinfectant solution. Example: Sporicidin ® Brand Disinfectant Solution.
5. Allow POC to air dry.
6. DO NOT place inside carry bag or run the POC until it is thoroughly dry.
7. When not in use, store the POC in a clean area free from grease, oil and
other sources of contamination.
Inlet Filter:
1. Remove the inlet filter by pulling on the protruding tab.
2. Wash filter with mild detergent. Rinse thoroughly with water and allow to
dry completely.
3. Once filter is dry, push the filter back into the case so only the small tab is
protruding.
Inlet Filter
Tab
RETURNS
Returned products require a Returned Goods Authorization (RGA) number,
contact Precision Medical, Inc. All returns must be packaged in sealed containers
to prevent damage. Precision Medical, Inc. will not be responsible for goods
damaged in transit. Refer to Precision Medical, Inc. Return Policy available on
the Internet, www.precisionmedical.com.
Manuals available on our Website; www.precisionmedical.com
DISPOSAL INSTRUCTIONS
This device may contain electrical components that are hazardous to the
environment. DO NOT dispose device into standard trash. Contact your local
waste Management for disposal of Electronic Equipment.