Part setting the system (using part 1) – RISCO Group GT480 User Manual
Page 6
P
P
P
P
a
a
a
a
g
g
g
g
e
e
e
e
4
4
4
4
Pre Exit Check.
At the start of the setting procedure, a fault
tone will sound if any non exit routes are
open. The display will show, for example:-
If the fault clears within 20 seconds then the exit tone will begin, if not,
the fault tone will continue until a valid User code is entered.
Part Setting the System (using Part 1).
Up to three Part Sets may be available for your system. Please refer to
the customer details at the rear of this manual for information about
Part Set zones. Part Set zones will be omitted from the system when
that particular Part Set is used. To set the system using Part 1.
1)
Enter a valid User Code followed by 1 (
).
2)
Retire to an unprotected area.
Note:
To abort the exit, enter a valid User Code.
Exit Now ! . . .
Zone 3
GardTec 480 User PR5831_11 5IN480UM_B A6 booklet.qxd 19/07/2007 17:18 Page 4