RISCO Group ProSYS™ PTM - Manual

Page 1
WisDom
WisDom
The Program Transfer Module (PTM) is used to
create and apply standard programming templates.
In addition, you can use the PTM on powered up,
properly functioning Main Panels, which have been
previously programmed
Note:
Some displays will differ depending on panel type and version.
Note
: If you download data from a WisDom you can
ONLY
upload to the same version and
panel type. If the wrong data is uploaded, in some circumstances, panel damage may
occur.
To create a Programming Template by copying from a programmed WisDom:
Use a programmed WisDom system to create a Programming Template to be applied to other WisDom
systems. The programming on the WisDom is ready for copying.
To copy from a programmed WisDom system into the PTM:
1. Position the PTM on J1 located on the PCB of the back panel with the red
LED FACING AWAY
from
the row of terminals
(See Fig 1).
The red LED flashes slowly.
2. Remove the J9 default jumper from its position (located next to the tamper switch on the PCB of the
front panel) on one pin and position it on both of the two pins.
3. Access the main Installer Programming menu by pressing
[9] [1]
from the regular operation
mode.
4. Without making any changes, exit the main Installer Programming menu by pressing
[0]
and press
to save. The LED on the Program Transfer Module flashes rapidly, and the keypad displays the
following:
Or
When the LED stops flashing rapidly, the WisDom beeps and displays the following
Then the display returns to the normal operation mode display.
Cont…