Elinchrom 19350 - Manual (Page 11)

9
Troubleshooting
Should an error occur, first check the following points:
Having this problem? Check the following points:
No flash unit can be triggered
with the Transmitter
Mode “All” is selected  Check if the Transmitter is switched ON.
 Check battery polarity.
 Check if the Receiver module is connected correctly to the unit.
 Check if the frequency selector switch is set to the same channel.
 Check if Transmitter is in the same trigger mode Speed or
Standard.
Some units do not fire when
triggered with the Transmitter
Mode “Grp” is selected  Check if the Channel selector switch is set to the same Group.
 Reduce distance to any “not working” unit.
 Check if Transmitter is in the same trigger mode Speed / Standard.
TEST flash works, but the
camera will not trigger flash
unit  Check hot-shoe fitting.
 Connect the 2.5 mm to PC SYNC cable instead of hot-shoe
connection.
Limited Distance range  Reposition the units.
 Increase the distance to walls and ceilings.
 Position the antenna of Transmitter and Receiver.
 Use an RX extension cable to reduce the distance between the
modules.
CE Statements
This device has been tested and found to comply with the requirements set
up in the council directive on the approximation of the law of member states
relating to EMC Directive 89/336/EEC, Low Voltage Directive 73/23/EEC and
R&TTE Directive 99/5/EC