RIGOL DG5000 Series - Manual (Page 192)

RIGOL Chapter 10 Advanced Operation
User’s Guide for DG5000 10-42
1. DHCP
 In DHCP mode, DHCP server in the current network assigns LAN parameters,
e.g. IP address, for the generator.
 Press DHCP to select “On” or “Off” to turn DHCP mode on or off.
2. AutoIP
 In AutoIP mode, the generator acquires IP address within 169.254.0.1 and
169.254.255.254 and subnet mask 255.255.0.0 automatically based on the
current network configuration.
 Press AutoIP to select “On” or “Off” to turn AutoIP mode on or off. When
DHCP and AutoIP modes are turned on at the same time, the instrument will
use DHCP mode. Therefore, to enable this mode, set DHCP as “Off”.
3. ManualIP
 In ManualIP mode, the LAN parameters of the generator, e.g. IP address, are
defined by users.
 Press ManualIP to select “On” or “Off” to turn ManualIP mode on or off. If
all the three IP configuration modes are “On”, the priority of parameters
configuration from high to low is “DHCP”, “AutoIP” and “ManualIP”.
Therefore, to enable this mode, set DHCP and AutoIP as “Off”.
 The IP format is nnn.nnn.nnn.nnn. The first nnn ranges from 1 to 223
(except 127) and the other three nnn range from 0 to 255. We recommend
that users acquire an available IP from your network administrator.
 Press IP Address and use the numeric keyboard and direction keys to enter
your desired IP. The setting is stored in the non-volatile memory and will be
loaded automatically when the generator is powered on the next time if
DHCP and AutoIP are set as “Off”.
Tips
 If all the three IP configure modes are “On”, the priority of parameters
configuration from high to low is “DHCP”, “AutoIP” and “ManualIP”.
 The three IP configure modes cannot be set as “Off” at the same time.