ROCKINGER RO 825 B - Manual (Page 3)

ROCKI NG E R
Member of JOST-World
16
GB
S Sa affe etty y iin ns sttrru uc cttiio on ns s R RO O
i i
8 82 25 5 B B
The safety instructions are summarised in a single chapter.
In any situation where the user of the trailer coupling is at
risk, the safety instructions are repeated in the individual
sections and marked with the warning symbol shown here.
When handling trailer couplings, tractor vehicles and trailers, the relevant
safety regulations in the respective country must be observed. Any safety
instructions in the operating manual of the tractor vehicle and the trailer
remain valid and must be observed.
For operation, maintenance and assembly, the safety instructions listed
below must be observed. Further safety instructions are then given in the
individual case which relate directly to the respective activity.
Safety instructions for operation
x The trailer coupling may only be operated by authorised persons.
x The installation and operating instructions of the respective trailer coupling
retain their validity and must be observed.
x Only use the trailer coupling and the towing eye of the trailer if they are in
perfect technical condition.
x Only carry out hitching / unhitching operations on firm, level ground.
x During hitching, nobody may stand between the tractor vehicle and the
trailer.
x After every hitching operation, the correct locked status of the trailer
coupling must be checked by means of the control pin or the remote
indicator. Only drive the rig in the correctly locked status
x Never reach into the opened coupling.
Safety instructions for maintenance
x For maintenance work, only use the specified lubricants.
x Maintenance work may only be carried out by qualified personnel.
Safety instructions for installation
x Installation may only be carried out by authorised workshops.
x Installation must be carried out in compliance with the relevant accident pre-
vention regulations and the technical regulations for mechanical equipment.
x Only original ROCKINGER components may be used. .
x Instructions and installation guidelines of the vehicle manufacturer must
be observed, e.g. type of fastening, clearances etc.
x All screwed connections must be tightened with the prescribed tightening
torque.
x Work may only be carried out on the trailer coupling when it is closed.
Risk of injury!
x The trailer coupling must be installed in accordance with these installation
and operation instructions and may only be carried out on agricultural or
forestry tractor machines in accordance with Directive 74/150/EEC.
x Type plates and warnings must be clearly visible before the coupling or
drawbar eye are used and must not be rendered illegible in any way. Paint
residues or protective foils must be removed.
Trailer couplings are vehicle connection parts which require
model approval and are subject to the highest safety re-
quirements.
Alterations of any kind shall cause the warranty to lapse and invalidate
the model approval, which in turn invalidates the vehicle operation
permit.
!
!