Rose Electronics CrystalView EX5 HDMI - Manual (Page 13)

OPERATION
Installation and Operations Manual 9
CrystalView HD Installation
It is recommended that initially, power to all equipment be off.
Refer to Figure 2 for a typical system installation diagram.
Installation of the CrystalView HD consists of:
1. Connect a USB cable from the transmitter’s USB Type B connector
to an unused USB 2.0 or 1.1 Type A port on the computer
2. Install an HDMI cable to the transmitter’s HDMI IN connector and to
the HDMI connector on the computer
3. Connect your remote monitor to the receiver’s HDMI OUT port
4. Connect a USB keyboard and USB mouse to two USB Type A ports
on the receiver unit
5. Install a compatible USB device to a USB Type A port on the
receiver unit. (Up to 4 hub levels can be installed, and 13 USB
devices)
6. Connect up to 330 feet of CAT5 UTP or better cable between the
Link port on the transmitter and the Link port on the receiver unit
NOTE: It is recommended that only CAT5 or better UTP solid core
wire cabling terminated with 8 conductor RJ45 connectors
on both ends be used. The combined length of any patch
cords using stranded conductors must not exceed 33 feet
(10 meters). With surface and premise cabling, do not
exceed the max cable length specification of 330 feet.
Connecting / applying power
7. Connect a 5V, 3A power adapter to an AC outlet and to the
Transmitter unit
8. Connect a 5V, 3A power adapter to an AC outlet and to the
Receiver unit
9. Turn on the remote monitor and boot the computer. Wait for
approximately one minute for the CrystalView HD units to initialize
NOTE: Use only the provided DC power adapters with this product.
Using substitute adapters may cause permanent damage to
the units and will void the warranty.