Rose Electronics CrystalView DVI Plus - Manual (Page 12)

6 CrystalView DVI Plus Installation and Operations Manual
Installation – Duallink / Single Video
The example in figure 4 shows a typical installation for the Duallink / Single Video
model. It is recommended that all equipment be turned off. The cables needed for
this installation are:
 1- DVI-D MM video cable
 1-USB Type A to Type B
 3- Multimode fiber cables 50µm or 62.5µm. E.g. I-V(ZN)H 2G50
(In house patch cable) or I-V(ZN)HH 2G62.5 (In house Breakout cable)
or I/AD(ZN)H 4G50 (In house OR Outdoor Breakout cable, stress
resistant) or A/DQ(ZN)B2Y 4G62.5 (Outdoor cable, stress resistant with
protection against animal biting)
 A point to point connection is required for the fiber cables. Having one or
more patch panels in the line is possible and allowed. Not allowed is a
connection from the fiber link interface to any other products, especially
telecommunications or network equipment.
Figure 4. Installation - Duallink / Single Video
1. Connect a DVI-D MM video cable from the DVI-D video card
connector to the corresponding connector on the local unit.
2. Connect a USB Type A to Type B cable from the USB connector on
the computer to the USB Type A connector on the local unit.
3. Connect a DVI monitor, USB keyboard and USB mouse to the
corresponding connectors on the remote unit.
4. Connect three fiber cables from the local to the remote unit
5. Attach your USB 2.0 compatible devices to the USB connectors on
the remote unit.
6. Plug-in the two supplied power adapters to the local and remote units
7. Power on the monitors, remote unit, local unit, and the computer