SAF OPAL LT - Manual (Page 3)

Table of Contents
Page Subject
3 Starter Selection
4 Installation Notes
5 Wiring
6 Starter
Settings
7 Motor Protection
8 Start-up Procedure
9 Technical Specification
10 Dimensions
Safety
• Read this manual carefully before operating the equipment and follow its instructions.
• Installation, operation and maintenance should be in strict accordance with this
manual, national codes and good practice. Installation or operation not performed in
strict accordance with these instructions will void manufacturer's warranty.
• Disconnect all power inputs before servicing the soft-starter and/or the motor.
• After installation, check and verify that no parts (bolts, washers, etc) have fallen into
the starter.
Attention
1. This product was designed and tested for compliance with IEC947-4-2 for class A equipment.
2. Use of the product in domestic environments may cause radio interference, in which case the user may
be required to employ additional mitigation methods.
3. Utilization category is AC-53a or AC53b. Form1.
4. For further information, see Technical Specification.
Warnings
• Internal components and P.C.B's are at Mains potential when the RVS-AX is
connected to mains. This voltage is extremely dangerous and may cause death or
severe injury if contacted.
• When RVS-AX is connected to Mains, even if start signal has not been issued, full
voltage may appear on motor's terminals. Therefore, for isolation purposes it is
required to connect an isolating device (C/B, switch, line contactor, etc) upstream to
the RVS-AX.
• Starter must be properly grounded to ensure correct operation and safety.
• Check that Power Factor capacitors are not connected to the output side of the soft
starter
The company reserves the right to make any improvements or modifications to its products without prior notice.
2