TA Triumph-Adler CX 8020 - Manual (Page 69)

2. Hold the mis-fed paper by both hands and pull it out
carefully without breaking.
NOTE
(1) Be careful not to touch on the Fuser Roller and the surrounding parts as they are very
hot. You will be burnt if you touch such parts.
(2) Be careful not to touch the Stripper Fingers as they are very sharp. Otherwise you may
be hurt.
3. Close the Exit Cover.
4. Open the Upper Unit (2).
Chapter 4 Error Treatment 4-10
2
NOTE
It is recommended to make Initial Cut after removing the mis-fed paper, as the cut paper
will remove the toner dirt on the Heat Roller or some other parts.
(The copy may have some dirty image if you do not make it.)
Refer to [3. 1 Initial Cut] on the page 3-2 for the way of Initial Cut.