TA Triumph-Adler CX 8020 - Manual (Page 81)

4. 2 Call Service Errors
If the machine has a fatal error, the Service Call Indicator (1)
lights to inform you of the error.
Also the Indication Part (2) indicates any of the following Error
Code.
Error Code Name of the error
E0 Fuser Error (High Temperature)
E1 Fuser Error (Low Temperature)
E2 EEPROM Error
E3 Cutter Error (Time Over)
E4 Cutter Error (Switch Abnormal)
E6 Pocket Door Error (Time Over)
E7 Pocket Door Error (Switch Abnormal)
E9 Exposure Lamp Error (Dark)
EA Exposure Lamp Error (Bright)
EC Counter Error
ED Developer Motor Error
EE Main Motor Error
EF Fuser Motor Error
It is impossible for the user to cure these errors to resolve these issues.
PLEASE CALL YOUR TRAINED SERVICE PERSONNEL TO RESOLVE THESE ERRORS.
If any of the above errors is displayed:
1) Turn off the machine, wait approximately 30 seconds, and then turn on the machine again.
2) If the same error code is displayed, turn off the machine, and then unplug the machine from
the wall outlet.
Call your service personnel.
Chapter 4 Error Treatment 4-22
1
STAND BY
SL
LIGHTER DARKER
FILM
VELLUM/TRACING
PLAIN PAPER
MEDIA
ROLL
CUT SHEET
C
CLEAR DECREASE INCREASE
LEAD EDGE
TRAIL EDGE
CUT MODE
DECREASE INCREASE
C
CLEAR
STOP
ALL CLEAR
2