Operation instructions 7. converting handle – SAF-HOLLAND XL-PH10399OM EH-3050 Series E-Hitch User Manual

Page 8

Advertising
background image

XL-PH10399OM-en-US Rev B · 2013-04-10 · Amendments and errors reserved. © SAF-HOLLAND, Inc.

8

Figure 7

Operation Instructions

7. Converting Handle

The E-Hitch is packaged with the handle
in the drop style position. The following
instructions are for converting the hitch
handle from a drop style to a fixed upright
style or vice-versa.

1. If E-Hitch is not mounted securely to

a vehicle the hitch frame should be
gripped in a vise of adequate size to
secure the Hitch while converting.

Failure to support hitch
pin while changing handle
could result in ejection
of hitch pin, which if not
avoided, may result in
minor or moderate injury.

2. Pull up on handle to retract the hitch pin.

3. Place a block of wood between the

hitch pin and E-Hitch frame and
release the handle.

4. Remove lock nut and bolt, pull out

the handle and rotate handle 180°

(Figure 7).

5. Replace lock nut and bolt . Tighten lock

nut to contact with pin plus 1/2 turn.
Handle will now fold down towards
the rear of the hitch.

6. Pull up on handle and remove block

of wood placed in Step 3.

7. Check for proper operation before

continued use of E-Hitch.

RECOMMENDED
PIN SUPPORT

ROTATE HANDLE 180°
ONCE REMOVED

Advertising