SAF-HOLLAND XL-FW503 FleetMaster LowLube Series Fifth Wheels with Manual Sliding Secondary Lock XA-201-S10217, XA-201-S10579 & XA-231-S10217 - Manual (Page 19)

XL-FW503 Rev B 19
LEFT HAND
(ROAD SIDE)
RELEASE
MANUAL
SLIDING
SECONDARY
LOCK
))))))))))))))))
➊
➌
➍
➎ ➐
➏
➑
➋
➒
➓
11
Figure 1 Figure 2
MANUAL SLIDING SECONDARY LOCK
Operating and Rebuilding Procedures
You must read and understand the standard FleetMaster operating instructions, along
with the following in the case where you have the manual sliding secondary lock. This
piece of literature is meant to be used in conjunction with Holland rebuilding literature
number XL-FW355-XX.
Item Part No. Description
1 XA-1674 Arm S/A Safety Release
2 XB-NRJ-34-F Nut Jam 3/4˝-16
3 XA-10216 Bar Tertiary Locking
4 XA-10213-2 Spacer Cover Plate
5 XA-10213-1 Spacer Cover Plate
6 XA-10212 Plate Cover
Item Part No. Description
7 XB-T-49 Washer, 1/2˝
8 XB-T-45-1 Lock washer, 1/2˝
9 XB-10620 HHCS, 1/2˝-13 x 2-3/4˝
10 XB-3545 Clip, Hitch Pin
11 XA-10215 Guide S/A Tertiary Handle
Manual Secondary Operation
Uncoupling
If equipped with a sliding secondary
lock, disregard use of rotating arm
secondary lock in Uncoupling Procedure
on page 11.
Follow this in its place:
1. Pull manual sliding secondary lock
handle out to the detent positions
(Figure 1).
Coupling
1. After following standard coupling
procedure, push manual sliding
secondary lock handle into lock
detent position (Figure 2).