Elation Professional PLATINUM BEAM 5R XM485-V1.0-NR - Manual (Page 16)

14
counter should be reset after every lamp change.
Lamp Off Time
This function displays the running time of the lamp from the last power on. The
display shows “XXXX”, where “XXXX” represents the number of hours the lamp
has been running since it was last struck. This counter is automatically reset
after every power-on.
Timer Password
Use this function to enter the “Clear Last Run” password. Password is “038”
Clear Last Run
This function will allow the “Last Run Hours” function be cleared and reset.
L-Timer Password
Use this function to enter the “Clear Lamp Time” password. Password is “038”
Clear Lamp Time
This function resets the lamp “ON” time to zero. Please reset the lamp “ON” time
at every lamp replacement. This procedure tracks the lamp running time so the
lamp can be replaced at the end of it’s recommended duty cycle.
• Select “Clear lamp time” in the system menu.
• The LCD will display “ON” or “OFF.” Were “ON” will reset the lamp time.
• Press enter to confirm.
• Press the Mode/Esc-button to return to the main menu.
Temperature Info.
This function will detail the internal head temperature in either Celsius or
Fahrenheit.
Software version
This function will display the current operating software version of the fixture.
• The LCD will read “V-X.X”, “X.X” represents the version number, e.g. “V-1.0”,
“V-2.6”.
• Use the UP and DOWN buttons to toggle through the software version of
different IC’s.
XM485-V1.0-NR