Elation Professional PLATINUM BEAM 5R XM485-V1.0-NR - Manual (Page 21)

19
Effect Adjust:
Test Channel – This menu function allows the user to select each individual
fixture channel and test it’s function independently from the control
board.
Lamp adjustment (manual control) – This function readies the fixture for lamp
optimization in a simple single step procedure. This function will center the pan and tilt
motors and at the same time open the shutter and bring the dimmer to 100%. The pan
and tilt function will still operate if the fixture needs to be positioned to a flat clear
surface. For more information on lamp optimization please see Section 6/Page 14.
Calibrate values – This function should only be performed by a qualified technician.
This function allows a user to make small adjustments to the effect wheels (color, gobo,
shutter, etc) to compensate for ware or in the event a sensor has been knocked slightly
out of place. Because improper use of this function can result in undesired operation this
function has been password protected. The password is 050 and must be entered each
time the calibration menu function is entered. Because calibration is an extremely
delicate procedure instruction on performing this action are left out of this manual. For a
first time calibrator, please contact our customer support team for step-by-step
instructions.
User Mode Set:
User mode – This function allows the user to create user defined channel orders
allowing the fixture to match the channel order of other fixtures on the market for easier
operation. A total of three user modes may be configured: User Mode A, User Mode B,
and User Mode C.
Edit User mode – This function allows the user to make the actual changes in the user-
defined modes that are created in the previous function.
EDIT PROGRAM: - The fixture comes equipped with a built-in DMX recorder that allows
custom programs to be installed and recalled directly from the fixture’s control board.
Programs can be created and stored using the fixture’s control board or by using an
XM485-V1.0-NR