Elation Professional PLATINUM BEAM 5R XM485-V1.0-NR - Manual (Page 17)

15
Lamp Control:
Lamp On or Off
This function allows manual control of the lamp power via the on-board system
menu.
• Select “ON” if you wish to strike the lamp or “OFF” to switch it off.
• Press “ENTER” to confirm.
• Press the Mode/Esc-button to return to the main menu.
Automatic La-On
When in the “ON” position, this function will automatically turn the lamp on when
power is applied to the fixture
Lamp On Via DMX
When engaged, this function will allow the lamp to be switched “on” via a DMX
controller. Select “ON” to enable this function or “OFF” to disable it.
Lamp Off Via DMX
When engaged, this function will allow the lamp to be switched “off” via a DMX
controller. Select “ON” to enable this function or “OFF” to disable it.
Lamp On at Temp.
The fixture is designed to shut the lamp off when an excessive temperature is
sensed inside the head by the on-board CPU. The lamp is shut down to prevent
damage to the lamp and avoids possible internal damage to the head. This function
sets the minimum temperature for lamp restrike after the lamp has been
automatically shut off.
Lamp Off at Temp.
The fixture is designed to shut the lamp off when an excessive temperature is
sensed inside the head by the on-board CPU. The lamp is shut down to prevent
damage to the lamp and avoids possible internal damage to the head. This function
sets the maximum internal operating temperature of the head before the lamp will
automatically be shut down. This function can be set to activate at an internal
temperature between 80° C and 139° C. Inside temperatures below 90° C are not
critical. Temperatures above 90° C should lead to the lamp being switched off.
Please note that the outside temperature should not exceed 45° C.
XM485-V1.0-NR