Avago Technologies AcceleRAID 160 - Manual (Page 16)

Performing an Installation
4 AcceleRAID 160 Quick Installation Guide
All the jumpers should normally be set to their default settings. Jumper
locations are illustrated in Figure 4 and described in Table 2.
Figure 4. AcceleRAID 160 Jumper Locations
If you have any difficulty with the operation or diagnostics of this controller,
contact Customer Support to see if any of the above jumpers need to be
adjusted.
Table 2. AcceleRAID 160 Jumper Descriptions
JP1 SCSI Activities LED Header
JP3 Maintenance Mode
JP4 Cache dirty (monitor cache write back) — LED Header
J1 Debug serial edge connector
JP1
JP3 JP4
J1