Avago Technologies AcceleRAID 160 - Manual (Page 24)

Performing an Installation
12 AcceleRAID 160 Quick Installation Guide
Connecting External SCSI Devices
8. If you are installing external SCSI devices to the controller,
individually or in an external drive cabinet, connect a cable, with the
68 pin VHDCI, to the external SCSI connector on the AcceleRAID 160
controller. Connect the other end of the cable connector to other
devices or to a SAF-TE external drive cabinet, as required
(see Figure 12).
9. External drive cabinets usually have termination built into the end of
the SCSI bus. Check the documentation that comes with your drive
cabinet to be sure this is the case. If not, use an active terminator at the
end of the bus.
☛
Note
AcceleRAID 160 termination is enabled by default,
but will be automatically disabled if necessary.
Figure 12. Connecting External SCSI Devices