PLANET WGS3-24240 - Manual (Page 415)

User’s Manual of WGS3-24000 / WGS3-24240
415
This command configures the tagging behavior for all interfaces in a VLAN to disabled. If tagging is disabled, traffic is
transmitted as untagged frames. The ID is a valid VLAN identification number.
▫ Format no vlan port tagging all <1-4094>
▫ Mode Global Config
8.6.75 vlan protocol group
▫ This command adds protocol-based VLAN group to the system. The <groupName> is a character string of 1 to 16
characters. When it is created, the protocol group will be assigned a unique number that will be used to identify the group
in subsequent commands.
Format vlan protocol group <groupname>
▫ Mode Global Config
8.6.76 vlan protocol group add protocol
This command adds the <protocol> to the protocol-based VLAN identified by <groupid>. A group may have more than one
protocol associated with it. Each interface and protocol combination can only be associated with one group. If adding a protocol
to a group causes any conflicts with interfaces currently associated with the group, this command will fail and the protocol will
not be added to the group. The possible values for protocol are ip, arp, and ipx.
▫ Default none
▫ Format vlan protocol group add protocol <groupid> <protocol>
▫ Mode Global Config
8.6.76.1 no vlan protocol group add protocol
This command removes the <protocol> from this protocol-based VLAN group that is identified by this <groupid>. The possible
values for protocol are ip, arp, and ipx.
▫ Format no vlan protocol group add protocol <groupid> <protocol>
▫ Mode Global Config
8.6.77 vlan protocol group remove
This command removes the protocol-based VLAN group that is identified by this <groupid>.
▫ Format vlan protocol group remove <groupid>
▫ Mode Global Config
8.6.78 vlan pvid
This command changes the VLAN ID per interface.
▫ Default 1
▫ Format vlan pvid <1-4094>
▫ Mode Interface Config
8.6.78.1 no vlan pvid
This command sets the VLAN ID per interface to 1.