PLANET MAP-3100 - Manual (Page 29)

Figure 3.3.3.3: VLAN1 – edit page
VLAN1 - edit page contain the following parameter:
a. Type – Click on “Type” drop down menu to select “Static” or “DHCP”.
b. Routed – Click on “Routed” drop down menu to select “Routable address” or “NAT
address”.
c. Comments – Specify the VLAN1 comments.
d. Active – Click on “Active” drop down menu to enable or disable VLAN1.
e. “Apply” button – Click on “Apply” button if you have made any changes. New
settings are active after the device reboot.
Note
1. ONLY VLAN 0, the default VLAN, is un-tagged packets. For VLAN 1 to
VLAN 15, it will be tagged packets at LAN interface after it is enabled.
And for Wireless interface, different SSID are required for different
VLAN.
2. The connected LAN device should support VLAN tagging if you plan to
connect wired device for different VLAN.
Page 29 of 102