PLANET ADW-4100 - Manual (Page 20)

ADW-4100 User Manual
14
be obtained from ISP. And VCI/VPI values must be obtained from them as well, for
some local ISPs don
’t offer this information actively.
To set up a PPPoE or PPPoA connection for WAN, follow the instructions below:
Step 1
Fill in the VCI/VPI entries with the information you get from ISP.
Step 2
Choose suitable packet encapsulation (PPPoA LLC/VC-Mux, PPPoE LLC/VC-Mux).
Disable
“Bridge”. (Packet encapsulation information also has to be obtained from
ISP.)
Figure 4-7: Encapsulation types of PPPoE/PPPoA
Service Name
If your ISP provides this info, please type it into the field or leave it blank (factory
default).
User Name and Password
Fill in the entries with the information provided by ISP.
Disconnect Timeout
It is the amount of time you would like to pass before the Router drops your Internet
connection due to inactivity. Enter zero (0) in the field to remain Internet connection
on at all time. The idle time ranges from 0 to 32767 seconds.
MRU
Maximum Receive Unit indicates the peer of PPP connection the maximum size of
the PPP information field this device can be received. The default value is 1492 and
is used in the beginning of the PPP negotiation. In the normal negotiation, the peer
will accept this MRU and will not send packet with information field larger than this
value.
MTU
Maximum Transmission Unit indicates the network stack of any packet is larger
than this value will be fragmented before the transmission. During the PPP negotia-
tion,the peer of the PPP connection will indicates its MRU and will be accepted. The
actual MTU of the PPP connection will be set to the smaller one of MTU and the
peer
¡¦s MRU. The default is value 1492.
MSS
Maximum Segment Size is the largest size of data that TCP will send in a single IP
packet. When a connection is established between a LAN client and a host in the
WAN side, the LAN client and the WAN host will indicate their MSS during the TCP