ProSoft Technology MVI56E-MCMR - Manual (Page 161)

MVI56E-MCMR ♦ ControlLogix Platform Reference
Modbus Communication Module with Reduced Data Block User Manual
ProSoft Technology, Inc. Page 161 of 225
May 13, 2014
The Send Command Control message uses the following parameters in the MSG
configuration:
Status Data can be returned to the processor using a "Get Attribute Single"
service type MSG instruction. If you follow the provided sample ladder logic or
use the provided Add-On Instruction (AOI), the Get Command Control Status
MSG will be triggered at the same time as the Send Command Control message
by the same controller tag, MCMR.CONTROL.C
MD C ONTROL P1.C MD T RIGGER for
Port 1 or MCMR.CONTROL.C MD C ONTROL P2C MD T RIGGER for Port 2.
The Get Command Control Status message uses the following parameters in the
MSG configuration:
A 5-word response will be passed back through the MSG instruction to the
controller tag array, MCMR.CONTROL.C
MD C ONTROL P1.C MD C ONTROL R ESP or
MCMR.CONTROL.C MD C ONTROL P1.C MD C ONTROL R ESP , depending on whether
the Event Command was sent for Port 1 (9901) or Port 2 (9911). The following
table lists the 5-word response data received.