Roborock S4 Max - Manual (Page 26)

25
Routine maintenance
Using the main brush cleaning tool
Use the main brush cleaning tool to remove any hair entangled
around the main brush.
Dustbin and filter
*Weekly cleaning is recommended
1. Open the top cover of the robot, squeeze the dustbin latch, and
remove the dustbin.
Main brush
*Clean weekly
Note:
If there is a large amount of hair, or hair is tightly entangled, remove it carefully to
avoid damage to the main brush.
1. Turn the robot over then unlatch and remove the main brush
cover.
2. Take out the main brush, remove and clean its bearings.
3. Remove the main brush cap, rotating in the unlock direction.
4. Use the supplied main brush cleaning tool to remove any
entangled hair.
5. Re-install the cap and bearings following the lock direction.
6. Re-insert the main brush and secure the brush cover.
Note:
Main brush replacement every 6-12 months is recommended.
Lock direction
Unlock direction
Main brush bearing
Alignment mark
Main brush cover
Latch
Main brush
Main brush cap