MIDEA 41" Bladeless Tower Fan & HEPA - Manual (Page 6)

 Page 6 
INSTALLATION INSTRUCTIONS
1
3 4
5 6
7 8
2
Buckle
1. Remove the air inlet grille.
2. Take out the pre-filter.
Press the raised part on
both sides to pull it
outwards and take out the
pre-filter.
3. Remove the protective film
of the filter.
4. Install the HEPA filter.
5. Install the pre-filter. Align
the slot position at the
bottom and buckle up the
upper U-shaped buckle.
6. Install the air inlet grille.
Align the upper two
buckles and press them
tightly, then press the two
sides at lower part, slowly
and gently buckle the air
inlet grille.
7. Install the adapter,Tighten
the plug with the socket
position of the base.
8. Plug power supply.
Buckling
position
• It is recommended to clean the filter once every two weeks and replace
it once every six months (the cleaning and replacement cycle can be
adjusted according to the use environment).