Roland KC-600 Stereo Mixing 4-Channel Keyboard Amplifier - Manual (Page 5)

5
Panel Descriptions (KC-400/KC-600)
Rear Panel
8 CH1–CH4 input jacks
CH1: BALANCED jack, MIC/LINE jack
CH1 is equipped with a phone-type MIC/LINE jack and a balanced
XLR-type BALANCED jack that is convenient for connecting a mic.
This channel supports levels ranging from mic input level
(-50 dBu) through line input level (-20 dBu) for sources such as a
sound module.
* Pin assignment of CH1 BALANCED jack
CH2–CH3: LINE jacks
Use these for connecting keyboards, sound modules, and other
devices.
They accept line level input (-20 dBu).
CH4/MONITOR IN jack
Use this for connecting keyboards, sound modules, and other
devices. This accepts line level input (-20 dBu).
You can use the [OUTPUT SEL] knob (p. 4) to specify the output
destination.
9 LINE OUT jack
Connect this to your mixer or recorder.
The EQUALIZER knobs and the [MASTER] knob do not affect the
volume or tone of the output from the LINE OUT jack.
* The KC-600 is equipped with XLR and phone jacks. These can
both be used simultaneously.
* Pin assignment of LINE OUT: BALANCED jacks
[GND LIFT] switch (KC-600 only)
Loop hum noise may occur when other external devices are
connected to the unit. In such instances, you may be able to
mitigate the problem by switching the position of the [GND LIFT]
switch. The [GND LIFT] switch should be normally set to OFF.
10 AUX IN (STEREO, R/L) jacks
Here you can connect an audio player, electronic musical
instrument, or similar audio source, and listen to it while you
perform.
11 SUB OUT jack
You can connect this jack to a powered subwoofer or an external
powered monitor. You can use the front panel knobs to adjust the
volume and tone of the output from the SUB OUT jack.
12 STEREO LINK (IN, OUT) jacks
By using these jacks, you can combine two units into an even
higher-output stereo system (p. 10).
13 PHONES jack
You can connect headphones here.
* The settings of the EQUALIZER knobs, the [SHAPE] button, and
the [MASTER] knob do not affect the output from the PHONES
jack.
14 AC IN jack
Connect the included power cord.
* Use only the power cord that was included with the unit.
2 HOT 1 GND
3 COLD
1 GND 2. HOT
3 COLD