Event electronic DEH-P8600MP - Manual (Page 41)

Selecting the channel in the
channel category
1 Press CLOCK and hold to select
Category.
Press CLOCK and hold repeatedly to switch
between the following channel select settings:
Channel Number (channel number select set-
ting)Category (channel category select
setting)
# You can also switch the XMchannel select
setting in the menu that apears by using
MULTI-CONTROL.
2 Push MULTI-CONTROL up or down to
select the desired channel category.
3 Push MULTI-CONTROL left or right to
select the desired channel in the selected
channel category.
Selecting the XM channel
directly
When using the remote control, you can select
the XMchannel directly by entering the de-
sired channel number.
1 Press DIRECT.
Channel number input display appears.
2 Press 09 buttons to enter the desired
channel number.
# You can cancel the input number by pressing
CLEAR.
3 Press DIRECT.
The entered XMchannel is selected.
Note
After entering the number input mode, if you do
not perform an operation within about eight sec-
onds, the mode is automatically canceled.
Display the ID code
Channel number select setting
If you select CH000, the ID code is displayed.
% Push MULTI-CONTROL left or right to
select CH000.
Channel category select setting
RADIO ID is provided as a channel category
for displaying the ID code.
% Push MULTI-CONTROL up or down to
select RADIO ID from channel category.
# If you select another channel, display of the ID
code is canceled.
# Display of the ID code repeats displaying
RADIO ID and the ID code one after the other.
XM tuner
En
41
English
Section
08