Battery for remote, Function & audio button operation, Use and care of the remote control – Event electronic DEH-P8600MP User Manual

Page 9: Before you start, Installing the battery, Using the remote control, Function button and audio button

Advertising
background image

Use and care of the remote

control

Installing the battery

Slide the tray out on the back of the remote

control and insert the battery with the plus (+)

and minus () poles pointing in the proper di-

rection.

! When using for the first time, pull out the

film protruding from the tray.

WARNING

Keep the battery out of the reach of children.
Should the battery be swallowed, immediately
consult a doctor.

CAUTION

! Use only one CR2025 (3 V) lithium battery.
! Remove the battery if the remote control is not

used for a month or longer.

! Do not recharge, disassemble, heat or dispose

of the battery in fire.

! Do not handle the battery with metallic tools.
! Do not store the battery with metallic materi-

als.

! In the event of battery leakage, wipe the re-

mote control completely clean and install a
new battery.

! When disposing of used batteries, please

comply with governmental regulations or en-
vironmental public institutions rules that
apply in your country/area.

Using the remote control

Point the remote control in the direction of the

front panel to operate.

! The remote control may not function prop-

erly in direct sunlight.

Important

! Do not store the remote control in high tem-

peratures or direct sunlight.

! Do not let the remote control fall onto the

floor, where it may become jammed under the
brake or accelerator pedal.

FUNCTION button and AUDIO button

You can also select the desired mode by

FUNCTION button and AUDIO button on the

remote control. But operation of FUNCTION

button and AUDIO button on the remote con-

trol differs from the operation of

MULTI-CONTROL on the head unit. When op-

erating the remote control, switch through the

modes as described below to select the mode.

FUNCTION button operation

% Press FUNCTION to select the desired

mode (e.g., built-in CD player).

Press FUNCTION repeatedly to switch be-

tween the following modes:

PLAY MODERANDOMSCANPAUSE

SEARCH MODETAG READCOMP/BMX

DISC TITLE

Note

Refer to Introduction of advanced built-in CD
player operation on page 20.

AUDIO button operation

% Press AUDIO to select the desired

mode.

Press AUDIO repeatedly to switch between

the following modes:

Before You Start

En

9

English

Section

01

Advertising