Event electronic DEH-P8600MP - Manual (Page 52)

4 Push MULTI-CONTROL left or right to
select cut-off frequency.
Each pushing MULTI-CONTROL left or right
selects cut-off frequencies in the following
order:
506380100125160200 (Hz)
Only frequencies higher than those in the se-
lected range are output from the front speak-
ers.
5 Push MULTI-CONTROL up or down to
adjust the output level of the front speak-
ers.
Each pushing MULTI-CONTROL up or down
increases or decreases the level of the front
speakers. ±0  24 is displayed as the level is
increased or decreased.
Setting the high pass filter for
rear speakers
1 Use MULTI-CONTROL to select R-HPF 1.
The function name tag R-HPF 1 is highlighted.
2 Push MULTI-CONTROL left or right to
select slope.
Each pushing MULTI-CONTROL left or right
selects slopes in the following order:
12 6Pass (0) (dB/oct.)
# If you set the slope to 0 dB/oct. (Pass), the
audio signal bypasses the filter, so the filter does
not have an effect.
3 Turn MULTI-CONTROL to select R-HPF 2.
The function name tag R-HPF 2 is highlighted.
4 Push MULTI-CONTROL left or right to
select cut-off frequency.
Each pushing MULTI-CONTROL left or right
selects cut-off frequencies in the following
order:
506380100125160200 (Hz)
Only frequencies higher than those in the se-
lected range are output from the rear speak-
ers.
5 Push MULTI-CONTROL up or down to
adjust the output level of the rear speak-
ers.
Each pushing MULTI-CONTROL up or down
increases or decreases the level of the rear
speakers. ±0  24 is displayed as the level is
increased or decreased.
Using the auto-equalizer
The auto-equalizer is the equalizer curve cre-
ated by auto TA and EQ (refer to Auto TA and
EQ (auto-time alignment and auto-equalizing)
on page 55).
You can turn the auto-equalizer on or off.
1 Use MULTI-CONTROL to select
AUTO-EQ.
The function name tag AUTO-EQ is high-
lighted.
# Please set Auto EQ appears. This indicates
that you cannot turn the auto-equalizer on if auto
TA and EQ has not been carried out.
2 Press MULTI-CONTROL to turn the auto-
equalizer on.
Auto EQ ON appears in the display.
# To turn auto-equalizer off, press
MULTI-CONTROL again.
Recalling equalizer curves
The equalizer lets you adjust the equalization
to match car interior acoustic characteristics
as desired.
Audio Adjustments
En
52
Section
11