Eagle Electronics EVR-100 - Manual (Page 13)

EAGLE EVR-100 Operation Instructions 13
To scan only one of your favourite channels, press 3CH then immediately press
and release SCAN. If you want to scan all three favourite channels, press 3CH then
immediately press and hold SCAN.
To add a favourite channel for the first time, select that channel then hold 3CH
to store it in the CH1 location. Repeat the procedure to store two more favourite
channels in the CH2 and CH3 locations respectively.
If you try and add another favourite channel it will overwrite the existing CH1. CH2
and CH3 remain unless you delete them.
To delete a favourite channel, select that channel then hold down 3CH until the C1,
C2 or C3 symbol disappears on the LCD.
SCAN Scan. Press to scan between your current channel and the priority channel in DUAL
WATCH mode. The weather channel is also scanned if the weather alert mode (ALT)
is ON.
Hold down SCAN to enter ALL SCAN mode where the priority channel is checked
every 1.5 seconds.
When a signal is received, scanning stops at that channel and BUSY appears on the
screen. If the signal ceases for more than 3 seconds, the scan restarts.
Press SKIP to temporarily skip over an “always busy” channel when in ALL SCAN
mode and resume the scan. An
is shown on the screen to designate a skipped
channel. Note that it is not possible to skip over the priority channel.
Press SCAN again to stop at the current channel.
+ CH - Channel Select. Also on the microphone. The current channel is shown on the
screen in BIG digits with an appropriate designator suffix A or B in small letters below
the channel number.
Press + CH - to step through the available channels one at a time, or hold down to
scroll rapidly through all the available channels. See Appendix for a listing of channel
charts.
Backlight switch. Press to turn on the backlighting, press again to turn off
Battery Level Check. Press to display the battery voltage level. The battery voltage
level will be displayed for 5 seconds before returning back to the previous screen.
SKIP Remove from ALL scan. Press to temporarily remove (SKIP) the channel from ALL
SCAN. The channel will be marked with an
. Press again to cancel the channel
SKIP.
H/L Transmission Power. On the microphone ONLY. High (HI) 7W or Low (LO) 1W. Press
to toggle between high or low transmission power for the entire channel bank. The
HI or LO selection is shown on the LCD.
Some channels allow only low power transmissions. Error beeps will sound if the
power transmission setting is incorrect.
Some channels allow only low power transmissions initially, but can be changed
to high power by holding down H/L and PTT at the same time. See Appendix for a
complete listing of channel charts.
PTT Push To Talk. On the microphone ONLY. Push to start transmitting.