England's Stove Works 25-EPI - Manual (Page 16)

Page | 16
• The 25-EP will perform equally well using softwood and hardwood pellets, and
although the ash may differ slightly in appearance or texture, both types of
pellets will burn cleanly and efficiently in this stove.
• The 25-EP is equipped with an automatic pellet ignition system; the only user
input required to light the stove is a simple press of the “On” button.
• Shortly after pressing the “On” button, the letters “S U” will appear in the heat
range and blower speed windows of the control board. This indicates the stove
has entered the start-up sequence and is operating normally.
• The fuel feed rate and combustion air during start-up is determined by the
control board, so the stove may be started on any heat range, although we
recommend starting the stove on Heat Range 5 to help ensure a strong fire is
initiated.
• After approximately fifteen minutes, the fire should be burning brightly and the
“S U” should disappear from the control board. At this point, the stove has
begun normal operation and the display windows on the control board will
remain empty unless the Heat Range or Blower Speed is adjusted.
Daily Operation Notes
• Variation in the flame height is normal, and may be particularly noticeable on
lower heat range settings. Not all wood fuel is uniform in size, which can affect
the way pellets are fed into the burnpot.
• Although the flame height may increase and decrease during operation, the
temperature of the exhaust gas remains relatively constant. Since heat is
exchanged from the exhaust gas and into the room, there is no loss of efficiency
during the periods of high and low flame.
CAUTION
NEVER USE GASOLINE, GASOLINE-TYPE LANTERN FUEL,
KEROSENE, CHARCOAL LIGHTER FLUID, OR SIMILAR LIQUIDS TO
START OR “FRESHEN UP” A FIRE IN THIS HEATER. KEEP ALL SUCH
LIQUIDS WELL AWAY FROM THE HEATER WHILE IN USE.